D3 digital speedo change to kph
I have changed digital speedo on the DIS from mph to kph for driving on continent by changing coding for region in instrument cluster but it's always just a temporary change. If I cycle ignition it is back to mph. The coding is saved and fuel usage stays in l/100km but the digital speedo always switches back to mph next time ignition is turned on.
Does anyone know how to make a permanent switch until I want to change it again as it is a bit of inconvenience to change the coding every time. |
Can this not be changed via MMI too? Seem to think I’ve done it that way once...
|
I had a look around in MMI but cannot find anything, could be down to version and firmware.
|
Quote:
|
|
I already have wide cluster, I think the older non wide clusters does not show digital speed at all.
If I change region coding to Germany for example digital speedo change to km/h, next time I turn ignition on it's back to mph but fuel consumption is still in l/100km and odometer reading is still in km |
Found it in the MMI in the end, no need to change coding.
It's in: Setup Settings (right top function button) Measurement units |
^^
Yes, this... . I just bought a UK Q7 , that was living in France, and he'd changed it all to KMH. Very annoying, took me a while to figure out how to change it all back ! |
All times are GMT. The time now is 05:23 AM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.