A8 Parts Forum

A8 Parts Forum (https://forum.a8parts.co.uk/index.php)
-   D3 - Axles, Brakes, Suspension and Steering (https://forum.a8parts.co.uk/forumdisplay.php?f=41)
-   -   Possible parking brake noise (https://forum.a8parts.co.uk/showthread.php?t=12540)

Simonbartlett 10th January 2017 08:07 PM

Possible parking brake noise
 
Tonight I parked my car on the drive put in park, didn't engage parking brake, got out and locked. A few seconds after locking something sounded like the hand brake cycling a couple of times. Is this normal or an electrical problem, I'm hoping its the car doing a check of some sort. Thanks

Lee S 10th January 2017 08:22 PM

Normal. If you select park and engage the steering lock it does a built in calibration where it winds out and then in. Nothing to worry about and should maybe be done once in a while anyway to re adjust and exercise the motors and screws etc. +++

Simonbartlett 10th January 2017 08:30 PM

Great news thanks one less thing to worry about

Johnmed 10th January 2017 08:32 PM

Completely normal and in my opinion quite bleeding annoying. When you arrive somewhere relatively quietly, park up and walk away, Mr Audi decides the whole occasion has been just that bit too quiet.

Next thing:

whirrrrrrr,.. whirrrrrrrrrrrr,.... ..... whirrrrrrrr,.. whirrrrrrrrrrrrrr.

:tuttut: Classy! :Confused:

Lee S 10th January 2017 09:28 PM

Why are you parking up and walking away without putting your handbrake on?:Confused::tuttut:

Johnmed 10th January 2017 09:29 PM

Quote:

Originally Posted by Lee S (Post 122606)
Why are you parking up and walking away without putting your handbrake on?:Confused::tuttut:

Cos it's in P!

Lee S 10th January 2017 10:29 PM

You should firstly use the EPB to secure the car no matter what the terrain is and then select the "Park" mode on the gearbox as extra security. Only using "Park" mode can cause wear to the locking pawl in your transmission (which, if it then shears, means your car will roll away) and, as you have noticed, cause frequent and unnecessary EPB calibrations, wearing out your EPB motors. Your hand has to pass over the EPB button twice when you stop, so what's the hardship in pulling the button up before you select "Park"? Better safe than sorry in my opinion but that's just me.... It's your car at the end of the day.

Johnmed 10th January 2017 10:44 PM

I take your point Lee. I use the EPB when at traffic lights etc and when parked not on level ground. However I'd always considered a pawl brake to be more than adequate on level ground.

Maybe I'll use it a bit more in future+++

Simonbartlett 11th January 2017 05:22 AM

Quote:

Originally Posted by Lee S (Post 122609)
You should firstly use the EPB to secure the car no matter what the terrain is and then select the "Park" mode on the gearbox as extra security. Only using "Park" mode can cause wear to the locking pawl in your transmission (which, if it then shears, means your car will roll away) and, as you have noticed, cause frequent and unnecessary EPB calibrations, wearing out your EPB motors. Your hand has to pass over the EPB button twice when you stop, so what's the hardship in pulling the button up before you select "Park"? Better safe than sorry in my opinion but that's just me.... It's your car at the end of the day.

I know you should and if not on level ground I always use the epb but my drive is perfectly level. I have always done this with Automatics and haven't broken a gearbox yet. I believe in America where nearly everyone drives an auto they actually call the hand brake an emergency brake and they hardly ever get used.

Joe2.0E 11th January 2017 07:43 AM

In the 5 years, I had a 2004 D3, I stopped using it unless I really needed to as it was the most unreliable set of components in the car. I had to replace the parking brake motors on both sides, the ecu and the switch in various stages over the first 3 years I had it.
One particular morning, the left hand motor had packed up in the on position on my driveway, much swearing and an hour later, I was mobile again.(There is a tool in the toolkit to manually unwind the caliper.)
Hence my reason for not using it.
The parts were revised a few times over the years and it may be more dependable on the later D3's but theres a lot to be said for a ratchet lever and a pair of steel cables.


All times are GMT. The time now is 01:35 AM.

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.