9 spoke D2 alloys - surplus to requirements now
 

I'm unlikely to use these again (they were on with my winter tyres from 2011 to 2015..), so I'm considering putting these on eBay, but thought I'd offer these on here first.

They're 18" rims, not 20s, and not OEM - but only Ian/IT noticed when I swapped my 20s for these, and they're in good, but not perfect, nick: two of them have visible nicks, and all have very minor markings, but they still look pretty good when on the car.

I'd be happy to accept £150 for the four of these without centre caps or tyres, and would consider selling these with the centre caps (as shown) and/or tyres as well for slightly more than this price, if anyone is interested in those: PM me if interested.

They could also be of interest to drivers of smaller Audis, do you have access to any of the other forums (where I sometimes lurk) such as AudiSRS, RS246 and even S2forum?

If not I could put links there? You'd need to specify the ET and rim width too..... (and manufacturer/type if known)

Thanks Andrew, I don't, so feel free: I also think - but don't know for sure - that the ET and rim width are the same as my other wheels (20" FEs, and 18" Avus and W12 rims), as they just bolt straight on. Or is it more complicated than that?

Yes.

People with other cars will want to know the PCD (presumably 5*112 like normal D2 wheels), the rim width (e.g. 8", 8.5", 9") to check body/suspension clearances and tyre sizes and finally offset (ET) to see if spacers are needed.

Most wheels that fit straight on a D2 will be around ET45, but the exact figure should be stamped on the wheels.
And I think 18" Avus are usually 8" whereas FE's are 8.5" from a D2 or 9" if from a D3.

I would like to know width and ET please :) Also, are they multi-fit (2 sets of holes) or just 5x112?

They're multifit, and I've yet to confirm the width and ET: they were running on 245/45/18 Michelin PA4s, if that helps (now fitted to my W12 wheels, which they'll stay on)

Edit: details from the back of the wheel as follows: 18 x 8J ET36 (might be 35? - it's hard to see), PCD 112.

Not really, 245/45/18 would normally be on 8" wheels, but can fit both 8.5" and 9".

18 x 8J ET36 is all you need to know, they're multi hole so will fit loads. Don't need to ask PCD they've come off a D2 so have to be 5x112 in one set of holes or they'd have not come off an D2 or any other VW group car from around that era. They'll fit A3, A4, A6, Seat, Skoda, Vw. obviously with 225x40x18

Just advertise them as 18" 9 spoke, multi hole replicas. for 150 notes. If someone wants to know the manufacturing codes, who made them and where, will they fit a Austin Allegro ect buy genuine wheels straight from the dealer.

If they are multi-fit the second set of holes is usually 5x100 - which means they will go onto things like the MK1 TT, the A3/S3 MK1, Cupra R, etc... loads of opportunities for sale.

List them on the facebook marketplace and you'll get a bite quickly

I'll take em +++