I'm trying to re-code the parts for the headlamp washers where you can reduce the wash cycles:
[09 – Cent. Elect.]
[Security Access - 16] (Enter code presented by program)
[Adaptation - 10] -> Channel 26 Change to desired number e.g. 10
However I can't get past the Security Access as no Code is presented.
Also fancy the needle sweep:
[17 - Instruments]
[Coding - 07] -> [Long Coding Helper] -> Byte 1 Bit -> 0 Change 0 to 1
Or Check the box for "Gauge Test/Needle Sweep active"
I don't see the Byte type info anywhere ie I don't get the 'Long Coding Helper' anywhere else either.
When I Recoded to tell the car it has LED DRLs it 'offered' a Security Code no problem.
I have a full legit Gendan VCDS doofer and both the Normal Software and the BETA Version to see if that offered any more help.
Any ideas folks