All you need is a TORX but certain flat head screwdriver will do the job as well
Just pull the lining, impossible to damage anything
Unplug the connector
Pull the pump out a little so you can have enough room to unclip the hose
If your bottle is full and water water is not gashing out at this stage then you know this will fix your issue.
Put pump on side as now you will have to pull a little rubber ring which is a filter and as soon you take it out water will gash out so keep the connector out of the way.
Let it drain and crack on with the rubber ring/filter
Remember, legionnaire spreads in the form of spray or steam.
You water company delivers even up to 4 bacteria of legionnaire a day, but its only dangerous in situations mentioned above. survives only in the range of 20-60 degrees
Clean the plastic mesh/filter, put it back, clip the hose back, insert the pump where it was, push the connector back on until clips, bend lining so the edge goes first behind the panel and it will all slide in nicely, 3 screws back on and you are done
__________________
2006 D3 S8 5.2 V10
Ceramic Brakes, Bang&Olufsen, DTV, DAB, Rear Camera, BT, TPMS, Soft Close, Auto Boot, AMI , 4 Zone AC, Home Link, All Electric Blinds, Fingerprint, Ski Hatch, Black Extended Leather, Heated Sport Seats, Alacantra, Carbon Trim inc Aluminium Pack 2.
2015 A3 S line 1.4 TFSI - for the missus to keep her away from my car.
Standard S-line equipment, no extras.
2006 D3 A8 3.7 V8 - SOLD but not forgotten
|