Cleaned up the torsen housing
Swapped the bearings and spur gears over
New gasket - amazingly, this was in stock at Milton Keynes so came overnight
The output flange should have a rubber gasket. Bizarrely, whoever put this gearbox back in used silicone sealant instead
Thats better
Torsen housing back together
Flipped it over and primed the oil pump with new Mannol AG52 oil. I did the filter as well but forgot to get a pic.
Nearly-new sump
Where the magnets
should be
Sump back on and oily bits finished
Engine and gearbox reattached at last. I don't have engine mounting brackets for the 32V so the engine is sitting on carefully calibrated lumps of carbon-foam composite