Ok, all done. The AV1 lead is on. Only took about 10 minutes. My steps were:
1. Remove interior cover by turning the two plastic screws a quarter turn
2. reach in an unplug the red 20 pin connect. I didn't need to remove the nav player
3. Slide the red cover sideways off the 20 pin connector block
4. make a note of the pin numbers indicated in each corner of the block and then insert the pins on the AV fly lead as per the instructions earlier in this thread
5. Slide the red cover back onto the connector block
6. secure the leads with a tie wrap
And that was it. I just need to add an AV source and test it.
I attach a few pictures.
Thanks again to all for your help. Much appreciated.
|