Get it all warmed up like alrerady said switch off ....(very important ), undo oil filter housing in the middle of the vee, think its 30 mm socket ( not 100% ) undo it till it just pulls out then let it stand ,this allows the cup full of oil in the housing to drain back to sump .
Vac it out with your sucker , fit your new oil filter and seal ( mann filters are good) , tighten oil filter housing up ... its only plastic , so 3 foot long breaker bar with scaffolding tube over that is not nessasary as with some i come across.
Add fresh oil up to the mark , run it up ,make sure oil light goes out , re check level , should be good to go .
|