Not chronologically viable to develop in to a product either tbh, while I have more pressing things to work on like heater valves and wiper linkages
It can go on the list for the future though.
Today's progress:
Broken rear springs
New replacement from Tradition
Subframe reassembled
Back in the car
The right gearbox seal is leaking. I've been meaning to make a tool to refit those for ages so today is the day.
Its quite tight in here to hammer a seal in!
The flange is held in with a single bolt
With the flange out the seal can be easily removed
A piece of threaded bar is screwed in to the diff, and then the tool can be tightened up to push the new seal in place to the proper depth.
New seal fitted
Replaced the CV boot while the shaft was out as it was perished and would fail soon
All done in time for a wheel alignment in the morning