View Single Post
  #6  
Old 3rd December 2019, 09:30 PM
MikkiJayne MikkiJayne is offline
Senior Member
 
Join Date: Jan 2012
Posts: 5,017
Default

You know I never thought of a slide hammer. The first time I did one of these bearings I didn't have a slide hammer and so never changed my techique after I got one.

If it went through the centre of the hub and pulled on the back of the bearing, rather than pulling on the hub it would be sure to get the whole thing out, assuming its heavy enough. I might try that on the next one
Reply With Quote