That's it
Now I have many of them
New hardware for the scuttle trim. The original outer bolts are NLA so instead I am using N10160204 which is a couple of mm longer but still has the black coating.
The snap nuts are N90342504 and the centre bolt is N10205604, both still available.
Engine all back together with a new thermostat
The original scuttle trim had been butchered by whoever hacked up the electronics box so that was replaced
New bolts in place
3d printed bolt cover
Every single screw on the electronics box cover was trashed so I just drilled them all out
Pretty gnarly but it cleaned up fine
I have run out of replacement hardware for the headlights and I'm not sure if the parts are still available until Monday. It was vexing me terribly to have to use ordinary bolts
Until of course I remembered Sergey's wing bolt covers
Bumper back on
I solved the leaking brake hose issue but didn't take any pics. It was a tiny burr on the end of the hardline flare left over from the previous hose which was stopping the flare from fully seating in the new hose so I filed that off and replaced it and now it's fine
Arch liners back in and wheels on tomorrow and then a quick road test