Thread: Brake Block
View Single Post
  #15  
Old 1st November 2018, 09:10 AM
lebesset lebesset is offline
Member
 
Join Date: Sep 2012
Posts: 77
Default

Quote:
Originally Posted by MikkiJayne View Post
I'll upload it to Youtube at some point. It makes an immediate improvement to the brake pedal feel without the car even moving so I think it will be of use to everyone. I'll make a thread about it

I do plan to print foglight grilles at some point yes. That's quite a big project though. We need to scan them in first, and I haven't made a scanner yet, then figure out what to print them from. The biggest challenge is how to get an acceptable surface finish on them. Straight off the printer is fine for stuff like this master cylinder brace, but not for cosmetic items. If we have to spend hours hand-finishing them then its cheaper to have them moulded, or just buy new ones.
re fog light grills ; I have the 2 piece type [ early FL ? ] with both actual grill pieces missing
can these be replaced by single piece type ; or are the grill pieces obtainable somewhere somewhere?
Reply With Quote