I'll upload it to Youtube at some point. It makes an immediate improvement to the brake pedal feel without the car even moving so I think it will be of use to everyone. I'll make a thread about it
I do plan to print foglight grilles at some point yes. That's quite a big project though. We need to scan them in first, and I haven't made a scanner yet, then figure out what to print them from. The biggest challenge is how to get an acceptable surface finish on them. Straight off the printer is fine for stuff like this master cylinder brace, but not for cosmetic items. If we have to spend hours hand-finishing them then its cheaper to have them moulded, or just buy new ones.