Updating MMI

[A8_Tony]

Got an error can't find module BO_D3...anyone got any ideas?

[PsYcHe]

Everything working OK otherwise?

Do you have B&O?

[A8_Tony]

Think it's going through now

Just trying to work out how to remove the cubby hole :confused: doh!!

[PsYcHe]

cubby hole has clips at the sides, not the top or bottom (i assume you mean the glovebox one).

You sometimes need to run the CDs 2 or 3 times to make sure it got everything.

[A8_Tony]

Originally Posted by PsYcHe

cubby hole has clips at the sides, not the top or bottom (i assume you mean the glovebox one).

You sometimes need to run the CDs 2 or 3 times to make sure it got everything.

Ah ha!....I guess the clips are located at the front?

Almost there with the update....telephone is showing as not installed, but I'm just running disk 3 through now...hopefully that'll sort the last bits out

[A8_Tony]

Going relatively smoothly....although telephone & DVB don't seem to be working at the mo.

Can a mod move this thread to the proper section when they get a mo? I posted in the wrong bloody place :confused:

[PsYcHe]

disk 2 needs run a couple of times to do the phone.. takes fookin aaaaaaaaages!!

DVB may have hit CP, but not sure, run all the disks again

[A8_Tony]

tried running disk 1 again, but it says there's nothing to update. Disk 2 is running through again now

Bloody pain in the bum if the TV has hit CP, but then again, I don't really use it, so it can wait until I can be arsed to go into a dealer

Next job? fit the AMI unit

[limoncello]

dont worry the ami will only take 5 minutes

[PsYcHe]

I assume you're doing the AMI as a parallel install rather than a swap? that's a bit more fiddle as you need to drop the globox out to run all the cables usually. Unless you really need to use the CD changer again, just swap it.