|
VCDS (aka Vagcom) For all your electronic debug / diag advice queries and mods. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Acc/Start Auth. 5 Faults Found
Hi there,
i have some errors on my car and i would like to share with you maybe we can find a solution. I will copy/paste the errors from VCDS log: Address 05: Acc/Start Auth. Labels: 4E0-910-131.lbl Part No SW: 4E0 910 131 HW: 4E0 909 131 C Component: FBS AUDID3 H03 0140 Revision: 01403903 Serial number: AUX3Z0D0333088 Coding: 0409600 Shop #: WSC 02311 785 00200 VCID: D8B516B96B08CA9 Part No: XXXXXXXXXXX Component: ELV XXXX 5 Faults Found: 00179 - Access/Start Authorization Antenna; Drivers Side (R134) 011 - Open Circuit Freeze Frame: Fault Status: 01101011 Fault Priority: 4 Fault Frequency: 0 Reset counter: 105 Mileage: 166112 km Time Indication: 0 Date: 2013.01.30 Time: 18:41:48 00180 - Access/Start Authorization Antenna; Passenger Side (R135) 011 - Open Circuit Freeze Frame: Fault Status: 01101011 Fault Priority: 4 Fault Frequency: 0 Reset counter: 105 Mileage: 166112 km Time Indication: 0 Date: 2013.01.30 Time: 18:41:48 00181 - Access/Start Authorization Antenna (in Rear bumper) (R136) 001 - Upper Limit Exceeded Freeze Frame: Fault Status: 01100001 Fault Priority: 4 Fault Frequency: 0 Reset counter: 105 Mileage: 166112 km Time Indication: 0 Date: 2013.01.30 Time: 18:41:48 00182 - Luggage Compartment Access/Start Authorization Antenna (R137) 011 - Open Circuit Freeze Frame: Fault Status: 01101011 Fault Priority: 4 Fault Frequency: 0 Reset counter: 105 Mileage: 166112 km Time Indication: 0 Date: 2013.01.30 Time: 18:41:48 00183 - Interior Access/Start Authorization Antenna 1 (R138) 011 - Open Circuit Freeze Frame: Fault Status: 01101011 Fault Priority: 4 Fault Frequency: 0 Reset counter: 105 Mileage: 166112 km Time Indication: 0 Date: 2013.01.30 Time: 18:41:48 Address 18: Aux. Heat Labels: None Part No SW: 4E0 910 105 HW: 4E0 265 081 F Component: Heizgeraet H06 0290 Revision: 0000000F Serial number: 00000009001484 Shop #: WSC 00000 000 00000 VCID: D9B313BD1002D31 1 Fault Found: 01406 - No Flame 000 - - - Intermittent ------------------------------------------------------------------------------- Address 19: CAN Gateway Labels: 4E0-910-468.lbl Part No SW: 4E0 910 468 HW: 4E0 907 468 B Component: Gateway H06 0070 Revision: 06 Serial number: 0100403517015F Coding: FEFFFFFF2B7504 Shop #: WSC 02555 823 55447 VCID: E5CB2F4D2C7A671 1 Fault Found: 01207 - Control Module for Auxiliary Heater (J364) 004 - No Signal/Communication - Intermittent Freeze Frame: Fault Status: 00100100 Fault Priority: 2 Fault Frequency: 2 Reset counter: 144 Mileage: 166090 km Time Indication: 0 Date: 2013.01.30 Time: 09:57:40 Address 25: Immobilizer Labels: 4E0-910-131.lbl Part No SW: 4E0 910 131 HW: 4E0 909 131 C Component: FBS AUDID3 H03 0140 Revision: 01403903 Serial number: AUX3Z0D0333088 Coding: 0409600 Shop #: WSC 02311 785 00200 VCID: D8B516B96B08CA9 Part No: XXXXXXXXXXX Component: ELV XXXX XXXXXXXXXXX ELV XXXX 5 Faults Found: 00179 - Access/Start Authorization Antenna; Drivers Side (R134) 011 - Open Circuit Freeze Frame: Fault Status: 01101011 Fault Priority: 4 Fault Frequency: 0 Reset counter: 105 Mileage: 166112 km Time Indication: 0 Date: 2013.01.30 Time: 18:41:48 00180 - Access/Start Authorization Antenna; Passenger Side (R135) 011 - Open Circuit Freeze Frame: Fault Status: 01101011 Fault Priority: 4 Fault Frequency: 0 Reset counter: 105 Mileage: 166112 km Time Indication: 0 Date: 2013.01.30 Time: 18:41:48 00181 - Access/Start Authorization Antenna (in Rear bumper) (R136) 001 - Upper Limit Exceeded Freeze Frame: Fault Status: 01100001 Fault Priority: 4 Fault Frequency: 0 Reset counter: 105 Mileage: 166112 km Time Indication: 0 Date: 2013.01.30 Time: 18:41:48 00182 - Luggage Compartment Access/Start Authorization Antenna (R137) 011 - Open Circuit Freeze Frame: Fault Status: 01101011 Fault Priority: 4 Fault Frequency: 0 Reset counter: 105 Mileage: 166112 km Time Indication: 0 Date: 2013.01.30 Time: 18:41:48 00183 - Interior Access/Start Authorization Antenna 1 (R138) 011 - Open Circuit Freeze Frame: Fault Status: 01101011 Fault Priority: 4 Fault Frequency: 0 Reset counter: 105 Mileage: 166112 km Time Indication: 0 Date: 2013.01.30 Time: 18:41:48 Address 28: HVAC, Rear Labels: None Part No SW: 4E0 910 158 HW: 4E0 919 158 B Component: KLIMA-STG. FOND 015 0210 Revision: 00000014 Serial number: 00000000015239 Coding: 0000000 Shop #: WSC 00000 000 00000 VCID: E1C33B5D38520B1 Part No: 4E0 910 772 A Component: Sitzluefter FS H02 010 Part No: 4E0 910 772 A Component: Sitzluefter BFS H02 010 4 Faults Found: 02299 - Supply Voltage Seat Vent; Rear Driver Side 011 - Open Circuit 02300 - Supply Voltage Seat Vent; Rear Passenger Side 011 - Open Circuit 02291 - Control Module for Seat Vent; Rear; Driver Side (J674) 004 - No Signal/Communication - Intermittent 02292 - Control Module for Seat Vent; Rear Passenger Side (J675) 004 - No Signal/Communication - Intermittent Address 53: Parking Brake Labels: 4E0-910-801.clb Part No SW: 4E0 910 801 D HW: 4E0 907 801 B Component: EPB A4EC0230 H03 0230 Revision: --H03--- Coding: 0000631 Shop #: WSC 52388 133 92782 VCID: 2045FE59F3D8C29 1 Fault Found: 02596 - Rear Brake Pads Worn 008 - Implausible Signal Freeze Frame: Fault Status: 01111000 Fault Priority: 6 Fault Frequency: 2 Reset counter: 105 Time Indication: 0 Freeze Frame: Voltage: 5.69 V Count: 61 Address 66: Seat, Rear Labels: None Part No SW: 4E0 910 860 HW: 4E0 959 860 Component: Sitz Fond H06 0050 Revision: 00000000 Serial number: 5DS 008 795-01 Coding: 0000009 Shop #: WSC 02555 823 55447 VCID: E1C33B5D38520B1 2 Faults Found: 02318 - Potentiometer for Lumbar Height / Massage; Left Rear (G424) 005 - No or Incorrect Basic Setting / Adaptation Freeze Frame: Fault Status: 01100101 Fault Priority: 4 Fault Frequency: 1 Reset counter: 105 Mileage: 30696 km Time Indication: 0 Date: 2005.03.11 Time: 11:54:00 02319 - Potentiometer for Lumbar Height / Massage; Right Rear (G425) 009 - Open or Short to Ground Freeze Frame: Fault Status: 01101001 Fault Priority: 4 Fault Frequency: 1 Reset counter: 105 Mileage: 30696 km Time Indication: 0 Date: 2005.03.11 Time: 09:53:27 I can confirm the car battery is on 100% also both remote controls have new batteries. |
#2
|
|||
|
|||
Could be that someone has been in at the module and not re-connected it properly.. And possibly hasn't reconnected the seats properly too, though that could be that the blower motors for the seat vents have broken.
__________________
2010 Jag XF 3.0D Portfolio S I know.. I know.. |
#3
|
|||
|
|||
Thanks for reply!
As for key-less issues seems like this is a common problem. I have seen on other Audi forums users complaining about it. I will bring the car this week to a highly recommended electrician working for Porsche Romania. Will keep you informed. |
#4
|
|||
|
|||
Update!
I have discovered that i am missing the memory buttons for driver seat. Since the car comes with memory seats according to ETKA and they are also present on the passenger side i am thinking that this could lead to errors for all Kessy antennas. Seems like someone removed the memory buttons in the past and now is just a simple black plastic cover in the place. Since the car cannot see the memory buttons anymore could lead to this error? I was about to order the kessy module plus steering column module but i would like to eliminate all possible ways before i order. Similar problem in the rear AC control. Car comes with ventilated seats for front and rear but in the rear the buttons allocated for ventilation are just simply plain black. The ones in the front are fine. So i am thinking at the same problem, since the rear AC control in the back is missing the command could lead to this errors. Who ever think that a car from Germany with full inspection service book with Audi dealer can have this dodgy job going on? |
#5
|
|||
|
|||
Do you have the fingerprint reader? If so, then you won't have driver memory buttons, they only came without the fingerprint scanner.
__________________
2010 Jag XF 3.0D Portfolio S I know.. I know.. |
#6
|
|||
|
|||
yes, i do have fingerprint scan. So, you mean to save the settings for each driver i have to create user under MMI?
|
#7
|
|||
|
|||
Exactly that.. so you won't have memory buttons, just the blanking plate.
Double check the module codings to make sure that it's set properly for that.
__________________
2010 Jag XF 3.0D Portfolio S I know.. I know.. |
#8
|
|||
|
|||
I have tried register myself as a user but i can only go till the moment "place the finger selected into the middle of fingerprint space". There is no message coming up or dirty sensor etc. The sensor is definitely clean. I deleted all previous users registered. What i am doing wrong?
__________________
S4 C4 Turbo Quattro |
#9
|
|||
|
|||
Pics
__________________
S4 C4 Turbo Quattro |
#10
|
|||
|
|||
It could be a faulty module (or fingerprint sensor).
__________________
2010 Jag XF 3.0D Portfolio S I know.. I know.. |
|
|