|
|
|||||||
| D3 - Interior Trims Seats, dashboards, plastics, everything inside the cabin |
|
|
Thread Tools | Display Modes |
|
#1
16th May 2019, 07:43 PM
|
|||
|
|||
Installing centre vents in dash
After removing lots of bits of trim and air vents to allow for MMI SCREEN repair......I noticed when reinstalling the centre vents that the control at the back (which moves ) is not inline with the control on the actual vent.
I think this movable pin is controlled by stepper motors? My question is, to move these to a new position (more central) do I use VCDS or is there a scenario with heating/cooling/recirculating that will move the position of these pins so I can push the centre air vents back into the dash and fully home?
__________________
Current: Graphite grey 2016 q7 3.0 (4m) Night blue - 2005 D3 4.2 TDi LWB My pride and joy - 1991 ur 20v quattro (owned since 2003). BMW 645 (Need to sell now I have 2 A8s....) Previous cars A8 D4 4.2tdi lwb (2011) A4 cab 3.0 Quattro petrol (2005) T5 Caravelle exec 2.5 (2006) A8 D2 3.7 quattro sport (2001) A8 D3 4.2 quattro (2003) A6 4.2 quattro avant (1999) A6 2.8 quattro (1998) Audi Coupe 2.6E (1993) Carlton 3.0 GSI 
|
|
|
Threaded Mode