A8 Parts Forum  

Go Back   A8 Parts Forum > A8 D2 > D2 - Lights

D2 - Lights Headlights, xenons, foglights. Everything outside the car that glows

Reply
 
Thread Tools Display Modes
  #11  
Old 5th October 2016, 09:32 PM
HPsauce HPsauce is offline
Senior Member
 
Join Date: Sep 2011
Location: Chilterns, almost over HS2!
Posts: 8,366
Default

How does that work through a hole in a thin aluminium panel?
Being an amateur I think I'll stick with the rubber/well nut solution if I need to do any more.
__________________
2003 D2 FL S8. Irish Green Pearl/Beige. Solar sunroof, auto-dim mirrors, electric rear seat functions, ski hatch retrofit; extended leather. Aftermarket DVB-T, reversing camera and full XCarlink (Bluetooth etc.).
2016 Volvo V40 T5 Cross Country (4WD) with ALL the toys including adaptive cruise etc. etc. Osmium Grey with Blonde/Charcoal leather interior. Polestar performance "optimisation". (A much rarer model than a D2 S8 by the way!) Oh, and a brand new engine at just under 30,000 miles on the factory one!
Finally: gone, but not forgotten.....
1998 D2 PF S8. AgateGrey/Platinum. Every option (I think) except electric rear seats, tiptronic steering wheel, ski hatch, towbar & dimming door mirrors.
e.g. Cruise control, NavPlus/TV, Bose, GSM, Xenons, Solar roof, Parking sensors, Alcantara/leather everywhere of course. (internal dimming mirror added later)
1998 (very early) Ford Focus 1.8 Zetec; ABS/TCS, Heated screen/mirrors, Aircon, Auto-dim mirror, Leather, Trip computer, Cruise control, OEM Ford SatNav with CD changer.
And before that a lot of Rover 800s, a few oddities, a lovely Triumph Dolomite 1850HL with Overdrive and way back in my schooldays an Austin Seven aka Mini 850!
Reply With Quote
  #12  
Old 5th October 2016, 10:01 PM
MikkiJayne MikkiJayne is offline
Senior Member
 
Join Date: Jan 2012
Posts: 5,017
Default

It crushes like a rivet, very much like your rubber nuts but permanent. They're all over the place in the D2 - pretty much anywhere you put a bolt in to the bodywork.

Reply With Quote
  #13  
Old 5th October 2016, 10:25 PM
HPsauce HPsauce is offline
Senior Member
 
Join Date: Sep 2011
Location: Chilterns, almost over HS2!
Posts: 8,366
Default

So do you only need access from the front to fit them, a bit like a pop rivet?
I can envisage fitting them with the bolt in place (not fully tightened) with a tool to pull on it and compress the fixing then unscrew the bolt.

Or do you just push it in through whatever needs fixing then tighten?
__________________
2003 D2 FL S8. Irish Green Pearl/Beige. Solar sunroof, auto-dim mirrors, electric rear seat functions, ski hatch retrofit; extended leather. Aftermarket DVB-T, reversing camera and full XCarlink (Bluetooth etc.).
2016 Volvo V40 T5 Cross Country (4WD) with ALL the toys including adaptive cruise etc. etc. Osmium Grey with Blonde/Charcoal leather interior. Polestar performance "optimisation". (A much rarer model than a D2 S8 by the way!) Oh, and a brand new engine at just under 30,000 miles on the factory one!
Finally: gone, but not forgotten.....
1998 D2 PF S8. AgateGrey/Platinum. Every option (I think) except electric rear seats, tiptronic steering wheel, ski hatch, towbar & dimming door mirrors.
e.g. Cruise control, NavPlus/TV, Bose, GSM, Xenons, Solar roof, Parking sensors, Alcantara/leather everywhere of course. (internal dimming mirror added later)
1998 (very early) Ford Focus 1.8 Zetec; ABS/TCS, Heated screen/mirrors, Aircon, Auto-dim mirror, Leather, Trip computer, Cruise control, OEM Ford SatNav with CD changer.
And before that a lot of Rover 800s, a few oddities, a lovely Triumph Dolomite 1850HL with Overdrive and way back in my schooldays an Austin Seven aka Mini 850!
Reply With Quote
  #14  
Old 5th October 2016, 10:57 PM
MikkiJayne MikkiJayne is offline
Senior Member
 
Join Date: Jan 2012
Posts: 5,017
Default

Yeah just like a rivet. It needs setting in place before you attach something to it as it takes quite a lot of force to crush it. A lot of the tools look like rivet guns but they have an male thread on to which the rivnut is screwed. Put it in the hole then operating the tool pulls the thread back out (like the pin of a rivet) and crushes the fitting in place.

I just use a home-made setup a bit like this:



Tightening the nut while holding the bolt still effectively crushes the rivnut as it pulls the bolt thread through it.
Reply With Quote
  #15  
Old 5th October 2016, 11:05 PM
HPsauce HPsauce is offline
Senior Member
 
Join Date: Sep 2011
Location: Chilterns, almost over HS2!
Posts: 8,366
Default

Ah, that makes sense.

For lightweight stuff like numberplate lights it's easier to just use the rubber ones inserted as you fix the item.
__________________
2003 D2 FL S8. Irish Green Pearl/Beige. Solar sunroof, auto-dim mirrors, electric rear seat functions, ski hatch retrofit; extended leather. Aftermarket DVB-T, reversing camera and full XCarlink (Bluetooth etc.).
2016 Volvo V40 T5 Cross Country (4WD) with ALL the toys including adaptive cruise etc. etc. Osmium Grey with Blonde/Charcoal leather interior. Polestar performance "optimisation". (A much rarer model than a D2 S8 by the way!) Oh, and a brand new engine at just under 30,000 miles on the factory one!
Finally: gone, but not forgotten.....
1998 D2 PF S8. AgateGrey/Platinum. Every option (I think) except electric rear seats, tiptronic steering wheel, ski hatch, towbar & dimming door mirrors.
e.g. Cruise control, NavPlus/TV, Bose, GSM, Xenons, Solar roof, Parking sensors, Alcantara/leather everywhere of course. (internal dimming mirror added later)
1998 (very early) Ford Focus 1.8 Zetec; ABS/TCS, Heated screen/mirrors, Aircon, Auto-dim mirror, Leather, Trip computer, Cruise control, OEM Ford SatNav with CD changer.
And before that a lot of Rover 800s, a few oddities, a lovely Triumph Dolomite 1850HL with Overdrive and way back in my schooldays an Austin Seven aka Mini 850!
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 05:13 PM.


Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.