Picture of A8 D3 toolkit
 

Hello,

My toolkit has some items missing. Could I ask someone to take a photograph to help me identify the missing items.

Thanks

Richardracer

Mine has items missing as well, I assume it has everything it needs. From memory I have wheel wrench, locking wheel nut key, screwdriver, warning triangle and a tool to remove the wheel centre caps.

You should have an L shaped tool to wind back the EPB as well manny +++

I'm sure mine is complete. It has pretty much everything you need in there for quick fixes!

I'll post a pic in a few hours when I'm with my car again +++

Hope this helps +++ Looks like I have an empty slot to the right of the top panel :Confused:

http://i59.tinypic.com/2rfsx6v.jpg

http://i61.tinypic.com/2edce85.jpg

http://i62.tinypic.com/b7doxk.jpg

Your empty hole is the same as mine.., I'm guessing that's the little 'wire' tool for removing centre caps.

I have the locking wheel nut adapter in that slot

Ah yes, could be. Well I have that curly prong thing for pulling the centre caps in the little black case which contains the locking nut

What about the hexagonal-shaped hole to the very left on the bottom panel?

Pretty sure bottom left is locking wheel nut

thanks Ollie
 

just what I needed. I am missing the right angled silver thing, the fuse remover (black part bottom right) and the tool to pull hib caps off by th look of it.

Cheers

Richardracer.

That's the tool for removing the wheel nut covers +++

The fuse removers are normally behind the fuse covers at each end of the dash near the fuses +++

Gents,

My toolkit is missing the doohicky that the twist screw locks the kit into place with.

Therefore it never stays closed even if I try and use a few Velcro pads.

The twist screw is there and OK its the mating part in the toolkit that it locks into. Can I buy that separately or is there a fix anyone has done?