In the morning the car was free from errors and the below appeared while I was using VCDS. I had the ignition on and engine off then I turned HVAC on to auto, afterwards the fault code was stored and reappeared if cleared.
Anyone else had this?
Tomorrow I'll go through the output tests and see if that can move the flaps. Failing that I'll have to remove the flap control motor and see what's what.
Code:
Address 08: Auto HVAC Labels: None
Control Module Part Number: 4E0 910 043 HW: 4E0 820 043 A
Component and/or Version: KLIMAAUTOMAT 015 0240
Software Coding: 1069057
Work Shop Code: WSC 02311 785 00200
VCID: 5ABB8B6F950D75EE5F-800E
1 Fault Found:
01274 - Air Flow Flap Positioning Motor (V71)
003 - Mechanical Failure
Freeze Frame:
Fault Status: 01100011
Fault Priority: 3
Fault Frequency: 1
Reset counter: 193
Mileage: 136099 km
Time Indication: 0
Date: 2016.01.23
Time: 12:33:32
Freeze Frame:
Voltage: 11.80 V
Temperature: 14.0°C
(no units): 121.0
(no units): 132.0
Temperature: -82.0°C