View Single Post
  #2  
Old 17th November 2016, 01:32 PM
Mechcanico Lee Mechcanico Lee is offline
Senior Member
 
Join Date: Jul 2015
Location: St Helens Haydock
Posts: 434
Default

Are we using vcds ?

go into the data blocks , look for compressor duty cycle also look for system pressure , with ac off .....big differences here with ambient temps but i reckon you should see 6/7 bar .....switch ac on and see how much higher pressure goes should be around 10/12 bar with condensor fans running

Does the climate panel have the set up button where you can turn ac onto the 'econ' settings .......make sure econ is set to off to enable compressor to run

Feel the air con pipes going up towards the bulkhead area ....one should be very cold and one will be hot with ac on .

If the pressures are good or thereabouts and pipe is cold but still no cold air sounds like blend motor door not shuting over to allow air to pass through evaporator .
Reply With Quote