Thread: Ride height
View Single Post
  #9  
Old 31st August 2010, 10:22 AM
Dezzy's Avatar
Dezzy Dezzy is offline
Senior Member
 
Join Date: Sep 2009
Location: N. Devon
Posts: 2,715
Default

Mine too, and has sport suspesion but just to throw a spanner in the works i suffer from heavy tyre wear on the inside edges of the front. When i had it checked with 4 way laser they found that i have too much camber, the only way to adjust camber is ride height and that means to cancel out the camber the car would need to sit heigher than it does now.

Ooh and the arms i replaced but did use the preloaded measurements when tightening them up. I don't think its possible to tighten them up with wheel on and on the ground. Not sure about the arms holding the car up, maybe i suppose if it were just guessed if this were the case i reckon they would wear quick due to the rubber bush being put under so much stress.

Don't know but won't be long and i'll be needing a pair of tyres for the front again.

Last edited by Dezzy; 31st August 2010 at 10:30 AM.
Reply With Quote