Used the free filament up the other day so ordered some new stuff.
SUNLU PLA+ (in grey).
Tried it out today and the results are looking good.
Although the spec says 205 to 230 degrees for the nozzle and nothing for the bed!
Tried it at 220 nozzle temp and room temp for the bed - big fail.
Set the bed to 60 degrees and all is good so will do some more trials and see how it goes.
Question for Ray and MJ - once you have finished printing do you take the spool of filament off or leave on?
Cheers
__________________
Andy.
Current cars:
BMW i4 M-Sport
Peugeot 207 (the sons)
Triumph Daytona 675 (2017 reg)
===========================
Gone but not forgotten
Ford Focus ST-2 Mk3 (the wifes) (stolen Oct 2023)
1972 T2 Bay Window Camper (Slow)
Audi TT Mk1 225 - now with coil-overs and a 7inch touchscreen infotainment centre
2003 A8 Sport 4.2 (with ACC & LPG) (Feed up with all the issues so passed it on to a forum member)
2000 A8 FL QS 4.2 (with RNS-E - Nice  ) (Engine poorly so sold on to be brought back by someone who has the time)
|