It's PLA+ - seems the same as PLA but needs extra heat at the nozzle
The cover is not to thick so easily slips over the phone (and off again if required).
Not the prettiest finish but seems sturdy enough - didn't take to long to print (was in the garage bending plexiglass to make a cover for one of my turntables) so very straight forward!
__________________
Andy.
Current cars:
BMW i4 M-Sport
Peugeot 207 (the sons)
Triumph Daytona 675 (2017 reg)
===========================
Gone but not forgotten
Ford Focus ST-2 Mk3 (the wifes) (stolen Oct 2023)
1972 T2 Bay Window Camper (Slow)
Audi TT Mk1 225 - now with coil-overs and a 7inch touchscreen infotainment centre
2003 A8 Sport 4.2 (with ACC & LPG) (Feed up with all the issues so passed it on to a forum member)
2000 A8 FL QS 4.2 (with RNS-E - Nice  ) (Engine poorly so sold on to be brought back by someone who has the time)
|