[Baryonyx]

Morning all,

I've recently acquired the 'A8' and '4.2' badge for my A8 in the post off the orginal seller, Bushido.

I was wondering how best to go about fitting these on a car, as I've never reattached a badge before. What material should I use to attach them? I've had doubled side sticking tape recommended, but the lettering of the badges is quite think and would obviously 'show' if I just taped it to the back of the badges!

Also, is there a means of working out positioning, or is a visual estimate taken from looking at badged A8's coupled with a small spirit level usually enough to provide a satisfactory result?

I also plan to move the Quattro badge back to it's original place, how will I remove this? A hair dryer to loosen it off and then re-attach it by the same means as the other badges?

Chris