To change the bonnet grill you will need a large stubby flat blade screwdriver. Inside the bonnet at the bottom of the grill are 3 screws. Remove them and the grill will fall out.
For painting your wheels I would suggest you need:
Socket set with allen key sockets to remove the calipers and strip the caliper from the caliper carrier.
Wire brush to clear the worst of the rust.
Some chemical to kill the rust befor you paint.
A proper jack (not from the boot) to lift the car and remove the wheels.
For the wing mirrors:
a seletion of small sockets
screwdrivers various
pin nosed pliers
__________________
Conan (the Librarian)
Watch it if you dare
Currently,
2000 S8, Merlin Purple, Leather Pack 1, Winter Pack 1, SPAX adjustable suspension, AP Racing 6 pot front caliper, 385mm fully floating disks, EBC Yellow Stuff Pads, Black Diamond grooved rear disks and predetor pads, D2 Doctors Brake Block.
1997 4.2 A8SQ - the Projekt. 12 years and ongoing!
1997 4.2 A8SQ - Ming Blue. Restoration sat waiting; saved from the Scrapyard
2003 C5 Allroad 4.2Q - Cobolt Blue. Towing car. Laid up awaiting manual conversion.
2005 C5 Allroad 2.5TDi FE - Grey - Workhorse.
2015 Q3QS SLine - Daytona Grey. Lots of extras! Long Haired Admirals cutter.
Previously
2003 C5 A6 1.9TDI FWD - Loaner from D2 Doctor Lifex
1997 S8 - Ming Blue. Loaned out and written off. I loved that car. My first engine swap after cambelt failure.
1996 4.2 A8SQ - Ming Blue. 178k on a cambelt! Trader's 8. Delivered to A8Parts at Lifex.
2003 2.8 A8SQ - powder blueish. Fill in for a while. Sold on.
1998 1.8T A4 Avant FWD. Ming Blue (there's a theme here), PEX for the 97 S8.
And a list of non VAG going back 40 years before I saw the light. 
|