I enabled the VIM in my MMI

[sloss]

I followed the Instructions for the job no problem.

It accepted the generated code and I input the new value.

Next I needed to re-set the MMI. The drawing was for a LHD car and the re-set did'nt work so I had a think and tried a different set of keys.

What a fright I got! It went off with a huge bang!

I fully expected smoke to start pouring out the dash.......

But it came back on OK. Everything is working including video in Motion.

Came in to work this morning watching the NEWS - oops! should I admit to that?

Stew,