|
|
|||||||
| D2 - Transmission Gearboxes, diffs, drive shafts. |
|
|
Thread Tools | Display Modes |
|
#3
2nd June 2011, 08:37 PM
|
||||
|
||||
It's even easier than that. Here is a bit more help.
To remove the half shaft: 1. Take out cener cap on wheel. 2. With wheel on the ground crack the half shaft bolt. You will need a big breaker bar. 3. Undo the anti roll bar 4. Crack the six torx bolts at the output flange. 4. Undo the lower control arms at the subframe. you may ned to lower the subframe slghtly. undo the 6 bolts on the inner shaft 5. Pull the suspension away fron the car and ease out the half shaft. 
__________________
Conan (the Librarian) Watch it if you dare Currently, 2000 S8, Merlin Purple, Leather Pack 1, Winter Pack 1, SPAX adjustable suspension, AP Racing 6 pot front caliper, 385mm fully floating disks, EBC Yellow Stuff Pads, Black Diamond grooved rear disks and predetor pads, D2 Doctors Brake Block. 1997 4.2 A8SQ - the Projekt. 12 years and ongoing! 1997 4.2 A8SQ - Ming Blue. Restoration sat waiting; saved from the Scrapyard 2003 C5 Allroad 4.2Q - Cobolt Blue. Towing car. Laid up awaiting manual conversion. 2005 C5 Allroad 2.5TDi FE - Grey - Workhorse. 2015 Q3QS SLine - Daytona Grey. Lots of extras! Long Haired Admirals cutter. Previously 2003 C5 A6 1.9TDI FWD - Loaner from D2 Doctor Lifex 1997 S8 - Ming Blue. Loaned out and written off. I loved that car. My first engine swap after cambelt failure. 1996 4.2 A8SQ - Ming Blue. 178k on a cambelt! Trader's 8. Delivered to A8Parts at Lifex. 2003 2.8 A8SQ - powder blueish. Fill in for a while. Sold on. 1998 1.8T A4 Avant FWD. Ming Blue (there's a theme here), PEX for the 97 S8. And a list of non VAG going back 40 years before I saw the light.
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode