![]() |
|
D2 - Body and Exterior Bumpers, bonnets, glass, trims - Everything outside |
|
Thread Tools
![]() |
Display Modes
![]() |
|
#1
|
|||
|
|||
![]()
Hi all,
On the advice of Notorious, who's really helpful, I'm posting here in the forums on this query. I have a Pre Facelift Audi S8 D2, in which I am about to fit the front heated windscreen from the Facelift model. We have ordered the screen from Audi, and I have the heater module/ecu/amplfier from A8Parts. Notorious had a lot of useful information on running the wires up to the screen, and how he connected in to his car. However, one little niggle I have is how to activate the heater module. There are two wires that connect in to the HVAC in order to activate it, before I start experimenting does anyone have any experience as to how these are used to activate the heater module? Is it just a case of a simple switch to ground it out, or does it need 12v, or does it use a signal from the HVAC? I was hoping to wire a switch in my dash similar to my rear heated window switch, in order to activate it manually. Does anyone have any experience with such a setup, or the operation of the heater module? Thanks! |
|
|