On the front it's quite easy if you have the springs mounted on the struts already. You can remove the 2 lock nuts that hold the strut into the top control arm carrier from inside the engione bay. Undo the nut and slide out the bolt from the lower control arm and you can jiggle the strut out and replace.
The after end can be a bit harder and a lot of typing so give me a call and I'll talk you through it. Did Chrisp17283 this morning and his whole front end on Saturday. Before anyone else says anything, yes we did get the rear lower control arms on the wrong way round!!!!! 
__________________
Conan (the Librarian)
Watch it if you dare
Currently,
2000 S8, Merlin Purple, Leather Pack 1, Winter Pack 1, SPAX adjustable suspension, AP Racing 6 pot front caliper, 385mm fully floating disks, EBC Yellow Stuff Pads, Black Diamond grooved rear disks and predetor pads, D2 Doctors Brake Block.
1997 4.2 A8SQ - the Projekt. 12 years and ongoing!
1997 4.2 A8SQ - Ming Blue. Restoration sat waiting; saved from the Scrapyard
2003 C5 Allroad 4.2Q - Cobolt Blue. Towing car. Laid up awaiting manual conversion.
2005 C5 Allroad 2.5TDi FE - Grey - Workhorse.
2015 Q3QS SLine - Daytona Grey. Lots of extras! Long Haired Admirals cutter.
Previously
2003 C5 A6 1.9TDI FWD - Loaner from D2 Doctor Lifex
1997 S8 - Ming Blue. Loaned out and written off. I loved that car. My first engine swap after cambelt failure.
1996 4.2 A8SQ - Ming Blue. 178k on a cambelt! Trader's 8. Delivered to A8Parts at Lifex.
2003 2.8 A8SQ - powder blueish. Fill in for a while. Sold on.
1998 1.8T A4 Avant FWD. Ming Blue (there's a theme here), PEX for the 97 S8.
And a list of non VAG going back 40 years before I saw the light. 
|