No air

[Alluminio]

Hi PsYcHe,

Yes I tried all the obvious things; changing modes, putting the fan on full and checking all the vents were open.

There's no air flow from any vent; windscreen, face-level or floor. No whirring from the flap motors. Nothing.

The control module 'works' fine, with the LEDs in illuminating in the switches and the fan display moving up and down (ad changing the speed of the fan), but no air flow.

I have not asked if the battery was disconnected during the service.

I have VCDS, so I will perform a scan to see if there are any error codes with the HVAC control unit. I would like to use the flap procedure in VCDS, but thus far cannot find the procedure; does any have a link?