View Single Post
  #1  
Old 3rd December 2018, 12:27 AM
steamship's Avatar
steamship steamship is offline
Senior Member
 
Join Date: Jun 2013
Location: Londonderry, Northern Ireland
Posts: 2,955
Default Looking Some Assistance in Stripping Electrical Loom

Currently working on one of the retrofits, and looking for a bit of assistance. Because of the complexities and options available on the D3, a retrofit isn't such an easy task, what with all the electrics.

I've gone through the two relevant looms and identified what I need to swap around between them. I'm just wondering what others have done in such a situation. I've seen the videos of people making the looms on a table, which has fittings to keep everything in place.

I only need to strip back about half of the loom, but don't want to end up with a pile of spaghetti at the end of the day. I had thought of using a sheet of plywood and hammering nails in at strategic locations, but can't figure out how to keep things in place.
__________________
2001 A8 D2 FL 3.7 Q - LPG Conversion, Engine: AKC, Gearbox:FBB, Colour:LY5X Aqua Blue pearl effect, Interior:WJ light beige/dark beige valcona leather with burr walnut inserts

My DIY jobs - Replaced alarm horn, Replaced Coolant Temp sensor, Updated RNS-D firmware, Installed Reversing Camera and Digital TV, Dashcam Installation, Retrofitted Rear Blinds, Auto-Dimming Rear View Mirror, Chrome Boot Struts

Sold! 2008 S8 D3 5.2 V10 - Engine: BSM, Gearbox:KLW, Colour:LY7F Suzuka Grey Pearl Effect, Interior:Black/Black with Silver/Black valcona leather with carbon atlas inserts, Bang & Olufsen, Heated windscreen, Soft-close doors, TV, DAB, AMI, Quad Zone, Auto Boot, Auto dim Mirrors, Keyless entry, PDC with rearview camera, AFS II Headlights

My DIY jobs - Fan Jet Windscreen Washers, Retrofitted Electric Side Blinds
Reply With Quote