|
|
|||||||
| D4 - Axles, Brakes, Suspension and Steering Brakes, Springs, shocks, steering racks, steering columns, suspension arms, wheel hubs etc. |
 |
|
|
Thread Tools | Display Modes |
|
#1
6th April 2024, 05:13 PM
|
|||
|
|||
Hub bolt torque
Hi all.
Can anyone tell me or point me towards the front hub bolt torque please? Its for the bolt that goes into the end of the driveshaft. I have a feeling its about 140lb/ft +180 degrees but could do with the correct data, Thanks Steve.
__________________
2010 D4 SE Executive 4.2 TDI 
|
|
#2
6th April 2024, 10:26 PM
|
||||
|
||||
|
Pretty much spot on. According to the following PDF in the 'D4 Technical Info' section, it's 200Nm + 180 degrees:
28-Service Manual Running gear front-wheel drive and four-wheel drive.pdf
__________________
2001 A8 D2 FL 3.7 Q - LPG Conversion, Engine: AKC, Gearbox:FBB, Colour:LY5X Aqua Blue pearl effect, Interior:WJ light beige/dark beige valcona leather with burr walnut inserts My DIY jobs - Replaced alarm horn, Replaced Coolant Temp sensor, Updated RNS-D firmware, Installed Reversing Camera and Digital TV, Dashcam Installation, Retrofitted Rear Blinds, Auto-Dimming Rear View Mirror, Chrome Boot Struts Sold!  2008 S8 D3 5.2 V10 - Engine: BSM, Gearbox:KLW, Colour:LY7F Suzuka Grey Pearl Effect, Interior:Black/Black with Silver/Black valcona leather with carbon atlas inserts, Bang & Olufsen, Heated windscreen, Soft-close doors, TV, DAB, AMI, Quad Zone, Auto Boot, Auto dim Mirrors, Keyless entry, PDC with rearview camera, AFS II HeadlightsMy DIY jobs - Fan Jet Windscreen Washers, Retrofitted Electric Side Blinds
|
|
|
|
Linear Mode
