Hi again,
So i've got a bit of a question on electrics as i'm not an expert so here goes.
So i used a step-down 12v to 5v 3A power supply module. I wired it to my add-a-fuse...
...earthed it and plugged the positive part of the add-a-fuse into the following slot...
Now i'm able to use my Dashcam and it powers up as it should.
Unfortunately, my iphone won't seem to charge. It won't even say 'accessory not identified' or anything.
Just wanted to check if anyone had any idea on how i might get phone charging to work?
Thanks,
Oliver