|
D3 - Interior Trims Seats, dashboards, plastics, everything inside the cabin |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Overhead light console removal.
Can anyone please post how to remove the front and rear overhead light consoles please. I have bought LED bulbs as an upgrade however the actual bulb holders are not the strongest and I have managed to break one in the front and 1 in rear. I now need to remove the consoles and replace the holders. Thanks in advance.
__________________
Audi A8 D3 Ice Silver Green. 3.0 TDI. |
#2
|
||||
|
||||
Here is a PDF format file that covers your request.
__________________
Ray at Wigan Pier 2014 A8L D4 4.0TFSI Gold (Sticker says "Beige") Can't leave you in a black smoke cloud anymore.. In progress, Nothing left to do. Gone 2004 A8 D3 3.0 TDI. Ebony Pearl Black (with little bits of other colours and glitter) |
#3
|
|||
|
|||
Oooooooo that's handy, my sunroof dial has decided to come lose so I was looking at how to get into it
|
#4
|
||||
|
||||
That PDF was for a D3, not sure if it is similiar to a D2.
Good luck anyway
__________________
Ray at Wigan Pier 2014 A8L D4 4.0TFSI Gold (Sticker says "Beige") Can't leave you in a black smoke cloud anymore.. In progress, Nothing left to do. Gone 2004 A8 D3 3.0 TDI. Ebony Pearl Black (with little bits of other colours and glitter) |
#5
|
|||
|
|||
I doubt its that different to be honest!
|
#6
|
|||
|
|||
I'm looking for a place to power a dashcam without having to bring a wire down the a-pillar. I thought about using the circuit for the On Star which I have since disconnected at the fuse panel because the green LED was very annoying when driving at night.
I've managed to remove the light covers and fascia. However on page two of the guide above, it states, Roof electronics control unit -J528- must be reencoded after renewing. Does this mean I have to use VCDS to reencode the roof electronics control unit if I remove the rest of the electronics? I do not have VCDS so I don't want to go any further if I need to. Thanks! |
#7
|
||||
|
||||
Quote:
In terms of finding power, check out the following thread by Delboy: http://forum.a8parts.co.uk/showthread.php?t=8377
__________________
2001 A8 D2 FL 3.7 Q - LPG Conversion, Engine: AKC, Gearbox:FBB, Colour:LY5X Aqua Blue pearl effect, Interior:WJ light beige/dark beige valcona leather with burr walnut inserts My DIY jobs - Replaced alarm horn, Replaced Coolant Temp sensor, Updated RNS-D firmware, Installed Reversing Camera and Digital TV, Dashcam Installation, Retrofitted Rear Blinds, Auto-Dimming Rear View Mirror, Chrome Boot Struts Sold! 2008 S8 D3 5.2 V10 - Engine: BSM, Gearbox:KLW, Colour:LY7F Suzuka Grey Pearl Effect, Interior:Black/Black with Silver/Black valcona leather with carbon atlas inserts, Bang & Olufsen, Heated windscreen, Soft-close doors, TV, DAB, AMI, Quad Zone, Auto Boot, Auto dim Mirrors, Keyless entry, PDC with rearview camera, AFS II Headlights My DIY jobs - Fan Jet Windscreen Washers, Retrofitted Electric Side Blinds |
#8
|
|||
|
|||
Quote:
That thread by Delboy is great too! |
|
|