Rear Arch chip protection.

[steamship]

Originally Posted by monkeyboyuk

Just need the material and make a rough template from the original while it’s on car

I noticed one side of mine was somewhat worn and shabby looking. Any idea of how we can remove the offending material?

In terms of DIY, I'd be inclined to just buy some PPF from eBay (other sources are available!), give that area a thorough cleaning and apply it myself.

[donp38]

I think I will get a set and then use them as a template for PPF...
Lets see how I get on...

[monkeyboyuk]

Surely a bit of heat like with normal adhesive films should do the trick, get the hairdryer out

I looked at mine today and they’re a filthy mess lol

Originally Posted by steamship

I noticed one side of mine was somewhat worn and shabby looking. Any idea of how we can remove the offending material?

In terms of DIY, I'd be inclined to just buy some PPF from eBay (other sources are available!), give that area a thorough cleaning and apply it myself.

[steamship]

Originally Posted by monkeyboyuk

Surely a bit of heat like with normal adhesive films should do the trick,

Will have to give that a go. Just been watching a few videos about PPF removal and suggestions are a heat gun or a steamer. I have both but might try my cheap steamer first.

[donp38]

I think I will try my Karcher steamer spot washer to remove.
then some white spirit followed with panel wipe.
then good to go...
Will let you know how I get on..

[monkeyboyuk]

Yep just not everyone got a heat gun or steamer so a hairdryer usually does the trick

Originally Posted by steamship

Will have to give that a go. Just been watching a few videos about PPF removal and suggestions are a heat gun or a steamer. I have both but might try my cheap steamer first.